Automatic lightning stroke location on transmission lines using data mining and synchronized initial travelling

J. A. Morales, Z. Anane, R. J. Cabral

Research output: Contribution to journalArticlepeer-review

5 Scopus citations

Abstract

The automatic location of lightning stroke impact point on transmission lines is one of the most crucial factors related to the behavior of Electric Power Systems, which can improve the swift recovery of electric power. The usual location of this phenomenon has been based on distance protection relays, which requires operation times of approximately one cycle. This paper presents a high-speed protection approach for the lightning-caused transient automated location on transmission lines or on ground. This work is based on the synchronized initial voltage-travelling waves at both ends of high voltage transmission lines. Lightning strikes at different sections along the 220 kV transmission line are detected at both protection relays by using an algorithm based on the ellipsoidal pattern previously presented in another research project. That methodology uses the projection of original signals. Thus, if these signals are located along the ellipsoidal pattern, the electric power system is operated under normal conditions. Unlike the aforementioned case, if the projected signals are located outside of the ellipsoidal pattern, it represents the presence of lightning strokes. After those signals are detected, initial voltage traveling waves measured by protection relays located at both ends of the transmission line are used in order to localize the lighting stroke impact point. At the instant that a lightning stroke hits either on the phase conductor or the ground, travelling waves propagate along the transmission line. Later on, depending on the impact point of atmospheric discharges, different time instances, which the travelling waves require to arrive at their respective ends, are determined. These times are used to calculate the distance from the impact point to both protection relays. Therefore, this paper presents a concise simple methodology for lightning stroke location on transmission lines or ground based in data mining to perform the signal detection and travelling wave times to determine the location along the transmission line. Simulations of lightning stroke signals on a 220 kV transmission line are carried out in the Alternative Transients Program (ATP). The results show that the behavior of the work is swift and effective in order to locate the impact point, especially in situations where flash current values, inception angles, distances from the impact point to protection relays, direct and indirect lightning and other factors, are considered, since it is immune to flash currents and other features. Finally, the proposed work could be considered as an alternative routine for protection relay algorithms

Original languageEnglish
Pages (from-to)547-558
Number of pages12
JournalElectric Power Systems Research
Volume163
DOIs
StatePublished - 1 Oct 2018

Keywords

  • Lightning location
  • Smart
  • Synchronized
  • Travelling wave

Fingerprint

Dive into the research topics of 'Automatic lightning stroke location on transmission lines using data mining and synchronized initial travelling'. Together they form a unique fingerprint.

Cite this